4.1.2.1 Transistors Symbols (Category B1)

 4.1.2.1 Transistors Symbols
(Category B1)



Comments

Post a Comment

Popular posts from this blog

Sub Module 7.18: Aircraft Non Destructive Testing (NDT) Techniques

Image
EASA PART 66 / SARI MODULE 7 NON-DESTRUCTIVE TESTING (NDT): Nearly all inspection operations on aircraft structures are carried out visually at intervals specified in the Approved Maintenance Schedule. Sometimes visual examination is not practicable, or there may be some uncertainty about the serviceability of a part and one of the methods of nondestructive examination may be used to determine its condition. Non-destructive tests seek to detect defects such as cracks or corrosion either at the surface of below it and a number of methods are presently in use. In each case the part being tested is not harmed in any way.  The selection of the method to be used will depend on the design of the structure, its accessibility and the nature of the suspected defect. 1. VISUAL INSPECTION Visual inspection is the oldest of the non-destructive methods of testing. It is a quick and economical method of detecting various types of cracks before they progress sufficiently to cause failure. Its rel...
Read more

EWIS BACKGROUND AND TARGET GROUPS

Image
EWIS TRAINING BACKGROUND Over the years there have been a number of in-flight smoke and fire events where contamination sustained and caused the fire to spread. Regulators and Accident Investigators have conducted aircraft inspections and found wiring contaminated with items such as dust, dirt, metal shavings, lavatory waste water, coffee, soft drinks, and napkins. In some cases, dust has been found completely covering wire bundles and the surrounding area. Research has also demonstrated that wiring can be harmed by collateral damage when maintenance is being performed on other aircraft systems. For example, a person performing an inspection of an electrical power centre or avionics compartment may inadvertently cause damage to wiring in an adjacent area. Aviation Accident Investigators have specifically cited the need for improved training of personnel to ensure adequate recognition and repair of potentially unsafe wiring conditions. To fully realise the objectives EWIS, operators, ho...
Read more

Sub Module 7.17: Aircraft Jacking

Image
      EASA MODULE 7A Sub Module 7.17 AIRCRAFT HANDLING AND STORAGE    AIRCRAFT JACKING: Aircraft may need to be jacked for a variety of purposes. These may include component changes, retraction tests, weighing of the aircraft and aircraft rigging checks. Care needs to be taken when jacking, to avoid damage to aircraft or equipment. Jacking points are provided in the wings and fuselage, at strong points, to enable the whole aircraft to be lifted, and there are, usually, other points, at the nose and main undercarriages, to enable individual wheels to be changed. Some aircraft require a jacking pad to be fitted to each jacking point, while in some, the jacking pads are built into the structure. Special jacking adapters and beams may be available to lift individual axles.   In all instances, the Maintenance Manual should be consulted, so that the correct equipment and procedures may be used. Because of the position of the jacking points, the C.G. of some aircr...
Read more