Aircraft AC Power Generation

 Aircraft AC Power Generation

 



Comments

Post a Comment

Popular posts from this blog

Sub Module 7.17: Aircraft Jacking

Image
      EASA MODULE 7A Sub Module 7.17 AIRCRAFT HANDLING AND STORAGE    AIRCRAFT JACKING: Aircraft may need to be jacked for a variety of purposes. These may include component changes, retraction tests, weighing of the aircraft and aircraft rigging checks. Care needs to be taken when jacking, to avoid damage to aircraft or equipment. Jacking points are provided in the wings and fuselage, at strong points, to enable the whole aircraft to be lifted, and there are, usually, other points, at the nose and main undercarriages, to enable individual wheels to be changed. Some aircraft require a jacking pad to be fitted to each jacking point, while in some, the jacking pads are built into the structure. Special jacking adapters and beams may be available to lift individual axles.   In all instances, the Maintenance Manual should be consulted, so that the correct equipment and procedures may be used. Because of the position of the jacking points, the C.G. of some aircr...
Read more

Approved Maintenance Organization | ANO145

 Essays: Question 1: You are the Quality Manager of an ANO-145 organization that carries out Line Maintenance of Boeing B777 Aircrafts. What requirements will you check before issuing the Certification Authorization to the Aircraft Licensed Mechanic in Category B1.1.  Question 2: An ANO-145 organization has a maintenance facility located outside Pakistan. What are the conditions under which the organization can use a certifying staff qualified in accordance with the national aviation regulations of the State in which the organisation facility is registered. Question 3: An aircraft is grounded at a location other than the main base where no appropriate certifying staff is available, how will the aircraft be released for service in this case.  Also write additional requirements for the maintenance organization if any. Question 4:  As per ANO-145 , what are different categories under which the aircrafts components must be segregated? Also explain how the unsalvageable i...
Read more

Sub Module 7.17 Aircraft Handling and Storage

Image
EASA MODULE 7A Sub Module 7.17 AIRCRAFT HANDLING AND STORAGE     AIRCRAFT TAXIING AND TOWING:      Aircraft need to be moved on the ground, between flights, for a variety of reasons, which can include:  Moving aircraft into, or within hangars for maintenance  Re-positioning aircraft for ground running or storm protection  Emergency removal of aircraft from a taxi-way.   It is important that the aircraft be moved safely, using the correct equipment, to avoid injury to personnel or damage to aircraft. Small aircraft, generally require little preparation but, with larger aircraft, some or all of the following points may be relevant: Preparation for the reception of the aircraft should be made in advance of its arrival. There should be adequate space available for the aircraft, with consideration given, as appropriate, to clearances for jacking, access for cranes etc. All equipment required for servicing should be available and serviceable. The...
Read more